35
Trendline 3
5.
Select the database(s) which should be installed and registered on the
database server.
6.
Click Next.
The selected databases will be installed and registered (attached) on the server
automatically.
7.
Click Finish, to exit installation.
4.1.4 Update
The Trendline software can check in user-defined
intervals whether an update for the Trendline of Detector
firmware is available for download from our Internet
server (see "Automatic notification of updates" ).
You can update the Trendline software and its components:
Update Trendline software
To update an existing Trendline software, proceed as follows:
Make a backup copy of your database(s),
uninstall the Trendline software and
run the Trendline setup .
The Setup Wizard guides you through the installation.
Update database in the Trendline software
If you want to use an existing database with the current Trendline version, it must
possibly be updated. When connecting to a database, the Trendline software
automatically checks the version number of the database and provides update
information if necessary. See chapter "Update database" .
Update Flash Updater software
If you want to update the Detector Flash Updater, proceed as follows:
Uninstall the Flash Updater software and
run the Flash Updater setup .
The Setup Wizard guides you through the installation.
Update Detector firmware
If you want to update the firmware of the Detector, you need the Flash Updater.
See chapter "Update firmware" .
36
102
36
22
98
36
22
267
To Next Page
Loading...
