25
Trendline 3
Installation type
The Trendline software can be installed in various ways. You can
install the software completely on a local computer (recommended for default
users)
or
distribute it to different computers (e.g. in a network).
If you want to install components individually, e.g. to
distribute them on different computers, make sure that
these computers have a network connection so that the
components can communicate with each other. In any
case the CM databases must be registered on the
computer where the database program is installed.
The following installation types are available:
Complete setup
All software components including databases will be set up on the system.
Start the installation file "Trendline-Setup*.exe" with double-click.
The Trendline Setup Wizard guides you through the installation.
Database setup
Only the database installations (Database program optional with databases) will
be set up on the system.
Start the installation file "TrendlineDatabases-Setup*.exe" with double-click.
The Database Setup Wizard guides you through the installation.
Flash Updater setup
Only the Flash Updater, to update the Detector firmware, will be set up on the
system.
Start the installation file "DetectorFlashUpdater*-Setup.exe" with double-click.
The Flash Updater Setup Wizard guides you through the installation.
26
30
28
To Next Page
Loading...
