7 Operations of CEMS2000 Monitoring Software
86
FOCUSED PHOTONICS INC
7.3.2.4 Correction Coefficient
This function is used for reading and setting the correction coefficient by the users, including
the corrections for SO
2
zero point, SO
2
calibration and NO zero point, as shown in Fig 7-45.
Fig 7-45 Correction Coefficient
You can click the “Read” button to read the information of correction coefficient and click
the “Set” button to save the settings. Click the “
” button at the top right of the window to return
to the main window.
7.3.2.5 Gas Measurement Range
This function is used for reading and setting the measurement range of the gas by the users,
as shown in Fig 7-46.
Fig 7-46 Measurement Range of the Gas
To read the measurement range of the gas:
To Next Page