EasyManuals Logo

Fronius Pull User Manual

Fronius Pull
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #161 background imageLoading...
Page #161 background image
Irregular wire feed speed
Hole in the contact tip is too narrow
Use a suitable contact tip
Faulty inner liner in welding torch
Check the inner liner for kinks, dirt, etc.
The feed rollers are not suitable for the wire electrode being used
Use suitable feed rollers
Feed rollers have the wrong contact pressure
Optimise the contact pressure
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Wire buffer empty
Counter lever on main wirefeeder open
Close counter lever on main wirefeeder
Acknowledge service code by pressing wire threading button
Main wirefeeder slipping
Check wearing parts on wirefeeder
Use suitable feed rollers
Decrease wire braking force
Increase contact pressure on main wirefeeder
Acknowledge service code by pressing wire threading button
End of wire reached
Check whether sufficient wire is available
Acknowledge service code using wire threading button
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Wirefeed problems
when using long hosepacks
Incorrect arrangement of hosepack
Arrange the hosepack in as straight a line as possible, avoid tight
bends
Cause:
Remedy:
Welding torch becomes very hot
Welding torch is inadequately dimensioned
Observe the duty cycle and loading limits
Only on water-cooled systems: inadequate coolant flow
Check coolant level, coolant flow, for coolant contamination, etc. For
further information refer to the cooling unit Operating Instructions
Cause:
Remedy:
Cause:
Remedy:
161
EN

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fronius Pull and is the answer not in the manual?

Fronius Pull Specifications

General IconGeneral
BrandFronius
ModelPull
CategoryWelding System
LanguageEnglish

Related product manuals