Intended use The devices and components described in these Operating Instructions are in-
tended exclusively for automated MIG/MAG applications in conjunction with
Fronius components.
Any use above and beyond this purpose is deemed improper. The manufacturer
shall not be held liable for any damage arising from such usage.
Proper use also includes:
-
Carefully reading and following all the instructions given in the Operating In-
structions
-
Studying and obeying all safety instructions and danger notices carefully
-
Performing all stipulated inspection and servicing work
The manufacturer likewise accepts no liability for inadequate or incorrect results.
Environmental
conditions
Operation or storage of the device outside the stipulated area will be deemed as
not in accordance with the intended purpose. The manufacturer shall not be held
liable for any damage arising from such usage.
Ambient temperature range:
-
during operation: -10 °C to + 40 °C (14 °F to 104 °F)
-
during transport and storage: -20 °C to +55 °C (-4 °F to 131 °F)
Relative humidity:
-
up to 50% at 40 °C (104 °F)
-
up to 90% at 20 °C (68 °F)
The surrounding air must be free from dust, acids, corrosive gases or substances,
etc.
Can be used at altitudes of up to 2000 m (6561 ft. 8.16 in.)
Obligations of
the operator
The operator must only allow persons to work with the device who:
-
are familiar with the fundamental instructions regarding safety at work and
accident prevention and have been instructed in how to use the device
-
have read and understood these operating instructions, especially the sec-
tion "safety rules", and have confirmed as much with their signatures
-
are trained to produce the required results.
Checks must be carried out at regular intervals to ensure that operators are
working in a safety-conscious manner.
Obligations of
personnel
Before using the device, all persons instructed to do so undertake:
-
to observe the basic instructions regarding safety at work and accident pre-
vention
-
to read these operating instructions, especially the "Safety rules" section and
sign to confirm that they have understood them and will follow them.
Before leaving the workplace, ensure that people or property cannot come to any
harm in your absence.
Mains connec-
tion
Devices with a higher rating may affect the energy quality of the mains due to
their current consumption.
9
EN
To Next Page
Loading...
Need help?
General
