PowerLiner
General
The PowerLiner is a wirefeeder system for all standard wire types. Wire diamet-
ers of 0.6 mm to 1.6 mm may be used.
The PowerLiner does not need an inner liner. The wire electrode is guided by
rollers set at an angle of 90 degrees. Seventy-six rollers are used for each metre
of wirefeeding hose. As a result, rolling friction rather than slip friction occurs
during wirefeeding.
The PowerLiner can be made up to any length. For Robacta Drive applications,
lengths of up to 10 m can be realised. For CMT applications, lengths of up to 6 m
can be realised between the unreeling wirefeeder and wire buffer and 4 m
between the wire buffer and drive unit.
A connection can be established to large spool systems, wire drums, welding
torches or wirefeeders using QuickConnect.
Pay attention to the wirefeeding direction when fitting the PowerLiner.
NOTE!
Use of the PowerLiner between the unreeling wirefeeder and SplitBox or
between the unreeling wirefeeder and wire buffer does not produce any advant-
ages in terms of wirefeeding, but is technically feasible.
61
EN
To Next Page
Loading...
Need help?
General
