PushPull hosepack
Gas-cooled
PushPull hosep-
acks
MHP 400i RD / G
Welding current at 10 min/40°C
M21 (EN 439)
C1 (EN 439)
40 % ED* / 400 A
60 % ED* / 320 A
100 % ED* / 260 A
-
60 % ED* / 400 A
100 % ED* / 320 A
Wire diameter 0.8 - 1.6 mm
0.030 - 0.062 inch
Length 0.935 / 1.085 /1.235 / 1.435 / 1.735 /
2.235 / 1.935 / 2.735 / 3.235 / 3.735 m
3.07 / 3.56 / 4.05 / 4.71 / 5.69 / 7.33 /
6.35 / 8.97 / 10.60 / 12.25 ft.
Voltage measurement (V-Peak) for
mechanically driven welding torches
141 V
The product conforms to the requirements of the IEC 60974-7 standard
* ED = Duty cycle
MHP 400i RD / G / PAP
Welding current at 10 min/40°C
M21 (EN 439)
C1 (EN 439)
40 % ED* / 400 A
60 % ED* / 320 A
100 % ED* / 260 A
-
60 % ED* / 400 A
100 % ED* / 320 A
Wire diameter 0.8 - 1.6 mm
0.030 - 0.062 inch
Length 0.915 / 0.925 / 0.945 / 1.025 / 1.045 /
1.075 / 1.105 / 1.115 / 1.135 / 1.165 /
1.175 / 1.185 / 1.205 / 1.295 / 1.335 /
1.355 / 1.385 / 1.415 / 1.495 / 1.575 /
1.935 / 1.985 / 2.115 / 2.265 / 2.385 /
2.585 / 3.415 m
3.00 / 3.03 / 3.1 / 3.36 / 3.43 / 3.35 /
3.63 / 3.66 / 3.72 / 3.82 / 3.86 / 3.89 /
3.95 / 4.25 / 4.38 / 4.45 / 4.54 / 4.64 /
4.9 / 5.17 / 6.35 / 6.51 / 6.94 / 7.43 /
7.82 / 8.48 / 11.20 ft.
Voltage measurement (V-Peak) for
mechanically driven welding torches
141 V
The product conforms to the requirements of the IEC 60974-7 standard
* ED = Duty cycle
183
EN
To Next Page
Loading...
