To Next Page

To Previous Page

Press and hold the wire retract button

After pressing the wire retract button, the wire electrode is retracted

by 1 mm (0.039 in.).

After a short pause, the wirefeeder continues to retract the wire elec-

trode - if the wire retract button remains pressed, the speed increases

every second by 10 m/min (393.70 ipm) up to the preset wire retract

speed.

Method 2

Retracting the wire electrode in 1 mm increments (0.039 in. increments) –

always press the wire retract button for less than one second (tap)

IMPORTANT! Do not allow long lengths of wire electrode to be retracted,

as the wire electrode is not wound onto the wirespool when retracted.

IMPORTANT! If there was a ground earth connection with the contact tip

before the wire retract button was pressed, the wire electrode will be re-

tracted when the button is pressed until it is short-circuit-free - it retracts

by no more than 10 mm (0.39 in.) with each press of the button.

If the wire electrode is to be retracted further, the wire retract button

must be pressed again.

(4) Wire threading button

For threading the wire electrode into the torch hosepack with no accom-

panying ﬂow of gas or current

While the button is pressed, the wirefeeder runs at the preset feeder

inching speed

Wire threading can be performed using one of two methods:

Method 1

Threading the wire electrode using the preset feeder inching speed:

Press and hold the wire threading button

After pressing the wire threading button, the wire electrode is thread

in by 1 mm (0.039 in.).

After a short pause, the wirefeeder continues to feed in the wire elec-

trode - if the wire threading button remains pressed, the speed in-

creases every second by 10 m/min (393.70 ipm) up to the preset feed-

er inching speed.

If the wire electrode comes into contact with a ground earth connec-

tion, the wirefeeding will be stopped and the wire electrode will be re-

tracted again by 1 mm (0.039 in.).

Method 2

Threading the wire electrode in 1 mm increments (0.039 in. increments) -

always press (tap) the wire threading button for less than 1 second

If the wire electrode comes into contact with a ground earth connection,

Fronius Pull User Manual

Questions and Answers: