Cleaning the Machine
163
Maintenance
10
Cleaning Document Feeder Rollers
If the document feeder rollers become soiled, smudges may appear on copies, or scanned
documents and paper jams may occur.
To ensure clean copies at all times, clean the document feeder rollers about once a month.
z
Do not use benzene, paint thinner, or other organic solvents. Doing so may damage paint or coating on
plastic parts.
z
Cleaning the machine with an excessive amount of water may cause the machine to malfunction or damage
documents during copying or scanning.
1 Lift the latch of the document feeder cover until it is completely open.
z
When you fully open the cover, it enters a fixed position. Open the cover gently.
2 While turning the rollers, wipe them with a soft cloth moistened with water.
z
Do not use cleaning agents other than water or neutral detergent.
z
Use a cloth firmly wrung to prevent water drops from falling into the machine. If water gets into the machine,
it may cause the machine to malfunction.
z
If you cannot remove dirt easily, gently wipe the rollers with a soft cloth moistened with a small amount of
neutral detergent.
3 Close the document feeder cover until it clicks into place, and confirm that there is no space
between the near or far side of the cover and the document feeder.
To Next Page
Loading...
Need help?
General
