Using CentreWare Internet Services
31
Environment Settings
2
[Apply] button
You can apply changes by pressing this button.
z
Reboot the machine to enable new settings.
Ethernet (Connectivity > Physical Connections)
Rated Speed
You can set the Ethernet port speed. You can select from Auto, 10 Mbps Half-Duplex, 10
Mbps Full-Duplex, 100 Mbps Half-Duplex, or 100 Mbps Full-Duplex. (Default: Auto)
MAC Address
The machine's MAC address is displayed.
[Apply] button
You can apply changes by pressing this button.
z
Reboot the machine to enable new settings.
TCP/IP (Connectivity > Protocols)
IP Mode
You can set the IP operation mode. You can select from Dual Stack, IPv4, or IPv6. The Dual
Stack setting lets you use both IPv4 and IPv6 addresses. (Default: IPv4)
General
Protocol
[Enabled] is displayed.
Physical Connection
[Ethernet] is displayed.
Host Name
[Host Name] is displayed.
IPv4
z
IP Address Resolution:
You can set the method used to acquire the IP Address, Subnet Mask and Gateway
Address. You can select from STATIC, DHCP, BOOTP, RARP, or DHCP/Autonet for the
address acquisition method. (Default: DHCP/Autonet)
z
IP Address:
You can enter the IP address when [STATIC] is selected for [IP Address Resolution].
z
Subnet Mask:
You can enter the subnet mask when [STATIC] is selected for [IP Address Resolution].
z
Gateway Address:
You can enter the gateway address when [STATIC] is selected for [IP Address
Resolution].
IPv6
z
Enable Manual Address:
You can check this checkbox to enter the IP address and gateway address directly.
(Default: Off)
To Next Page
Loading...
Need help?
General
