2. Install the rear case.
• When cable is in the wall:
Transmission cable
Power supply cable
Rear case
Screws
Putty
Trap
• When cable is in the wall (switch box is used):
Transmission cable
Power supply cable
Rear case
Screws
Switch box
• When cable is along the wall:
Cut off
Front case
Cable cover*
Epoxy
putty
*: More than 1 mm thick
NOTES:
• When central remote controller (UTY-DCGZ) is installed at the wall directly, install at
a flat wall so that small animals do not enter from the rear side.
• When central remote controller (UTY-DCGZ) is installed at the wall directly, remove
the rubber bush at the rear side.
2-4. Central remote controller (UTY-DCG
Z)
- (05-43) - 2. Control units
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
