Fujitsu AJ 126LELDH Series - Setting on Indoor Unit PCB

2-2. Setting on indoor unit PCB
Components related to function setting are located on the indoor unit main PCB.
¢ Components location
Related components location is differ depending on the type of the indoor unit as follows:
Type of PCB Type of indoor unit
Type 1
Compact cassette, 4-way flow cassette, Low static pressure duct (Mini duct), Low static
pressure duct (Slim duct)/Slim concealed floor, Low static pressure duct (High efficiency),
Medium static pressure duct, High static pressure duct, Floor/ceiling, Ceiling
Type 2
Wall mounted (ASA018, 024)
Type 3 3D flow cassette
Type 4 Circular flow cassette
Type 5
Wall mounted (ASA030, 034)
Type 6 Compact floor
Type 7
Wall mounted (ASA004, 007, 009, 012, 014, ASE004, 007, 009, 012, 014)
Type 8 One way flow cassette
• Type 1:
SET1SET2
DIP switch
(Type A)
SW1
Main PCB
DIP switch
(Type B)
Rotary switch
(Type C)
Rotary switch
(Type D)
DIP switch
(Type A)
SW601 SW602
SW604 SW605 SW606 SW607 SW608
SW PCB
NOTE:
SW1 may not be available depending on the models.
2-2. Setting on indoor unit PCB
- (07-74) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS