Fujitsu AJ 126LELDH Series - KNX Convertor for Indoor Unit

2-23. KNX convertor for Indoor unit
¢ Switch location
Set Programming (Prog) button on the KNX convertor PCB.
Prog button
PROG LED
<RED>
LED5
<GRN>
LED6
<ORG>
LED7
<RED>
¢ Programming (Prog) button setting
• Prog button: Mode setting when communicating with the ETS
Push to switch between Runtime mode and Programming mode.
PROG LED Mode setting Factory setting
ON Programming mode
OFF Runtime mode ♦
¢ Configuration and setting up
This is a fully compatible KNX device which must be configured and setup using standard KNX
tool ETS.
For how to configure the settings from the ETS, refer to the Interface Specification.
ETS database for this device can be downloaded from:
https://fujitsu-general.com/global/support/downloads/vrf/index.html
2-23. KNX convertor for Indoor unit
- (07-137) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS