Fujitsu AJ 126LELDH Series - Controller; Touch Panel Controller

4. Controller
RELATED LINKS
"Touch panel controller" on page 08-27
"Central remote controller (UTY-DCGZ)" on page 08-32
"Function summary of controller external input/output" on page 08-38
4-1. Touch panel controller
External input and output functions and related components are as follows:
External input External output Connector
External connect kit
(Optional parts)
Control input —
TM201
(CN411 or CN412)
—
Electricity meter — —
— Operation status
CN410 UTY-XWZXZA
— Error status
RELATED LINKS
"External input" on page 08-27
"External output" on page 08-31
"Optional parts" on page 08-31
"Function summary of controller external input/output" on page 08-38
¢ External input
This function performs “Emergency stop” or “All On / All Off” by using the signal to be input externally
at external input terminals.
 Input select
Use either one of Apply voltage terminal of Dry contact terminal according to the application. (Both
types of terminals cannot be used simultaneously.) For more details, refer to the operation manual of
Touch panel controller.
It is possible to switch to the Dry contact terminal or the Apply voltage terminal by connecting CN201
of TM201 on the PCB to CN411 or CN412 on the PCB of the panel side.
* The Dry contact terminal (connected to the CN411) is set at the time of factory shipment.
TM201 - K1, K2 Connect with the CN201
Dry contact terminal CN411
Apply voltage terminal CN412
4-1. Touch panel controller - (08-27) - 4. Controller
EXTERNAL INPUT AND OUTPUT EXTERNAL INPUT AND OUTPUT