Fujitsu AJ 126LELDH Series - Signal Amplifier

2-21. Signal amplifier
¢ Switch location
SW3 SW4
SW7
SW2
SW1
D19
D9
D14
¢ Automatic address setting
Refer to "Automatic address setting of signal amplifier" on page 07-57.
¢ Manual address setting
1. Turn on the power for the signal amplifier.
D19 D19
2. While holding down SW4 (the set button), press and release SW7 (the reset button) to en-
ter the address setting mode.
The address setting mode is activated only if the set button is held down when SW7 re-
leased.
D19
3. Press SW4 (the set button) to display the current address. The address is set to A1 at the
factory.
D19
Example 1: When A1 is set Example 2: When A12 is set
2-21. Signal amplifier - (07-133) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS