4. Press SW3 (the mode button) to select the address. The displayed address changes as
follows each SW3 button is pressed. When the manual setting is selected, the indicators
change as follows:
A1 A2
A8
A3
A7
A4
A6
A5
Filter mode: OFF
A30
A27 A28A25 A26 A29A1
A56
Filter mode: ON
D19
Example: Address No.5 is selected
• Press the SW3 when A9-A16 or A57-A88 is displayed, then A1 will be displayed.
• If connecting multiple signal amplifiers, be sure to select a different address for each am-
plifier.
• If the same address is used for different signal amplifiers, normal communication cannot
be done.
5. Press SW4 (the set button) to set the selected address.
Example: Address no.5 is set
D19
6. Turn the power off and on or press SW7 (the reset button) to exit the address setting mode
and return to the normal mode. If an address setting error occurs (“26” is displayed on the
D19-indicator), the address will not be set. Perform address setting again.
Normal mode Address setting error
D19 D19
2-21. Signal amplifier - (07-134) - 2. Function settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
