Fujitsu AJ 126LELDH Series - Wired Remote Controller (UTY-RLR)

2-17. Wired remote controller (UTY-RLR)
¢ Remote controller address confirmation
1. Select “15” in Menu 2 settings. Then press the ENTER button.
2. The address of this unit is displayed on the screen.
“ ” is displayed:
Address automatically
allocated
Address manually
allocated
Remote controller address
Not displayed:
01 to 32
Press the ENTER button to return to the Menu 2 item selection screen.
NOTE: The address of this unit is set automatically. Do not change the indoor unit remote con-
troller address from the factory setting “0”. (Verify that the address is “0”.)
¢ Master or slave setting of remote controller
1. Select the “06” in Menu 2 Settings. Then press the ENTER button.
2. Select the “0: Master” or the “1: Slave” with the + or - buttons.
: Master : Slave
2-17. Wired remote controller (UTY-RLR
)
- (07-125) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS