1-2. Address setting
Address for each unit should be preset before starting system operation. Refer to "System design" in
Chapter 6. SYSTEM DESIGN on page 06-1 to confirm the details of each unit, and perform the set-
ting.
¢ Outdoor unit addresses and setting ranges
Setting
Setting
range
Type of switch Remarks
A
Refrigerant circuit
address
00—99
Setting example
01
Arbitrary numbers can be set in
range of 00—99.
Terminal resistor ON/OFF
DIP switch SET5-4
Refer to "Terminal resistor
setting" on page 07-63.
1-2. Address setting - (07-4) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
