Fujitsu AJ 126LELDH Series - System Type Setting

1-1. System type setting
Other than the units mentioned below, refer to "Function settings" on page 07-66 and the installa-
tion manual.
¢ Outdoor unit setting
<Step 1>
Refrigerant circuit address setting
Set the rotary switch REF AD x10 and x1.
For details of switch, refer to "Address setting" on page 07-
4.
↓
<Step 2>
Terminal resistor setting
Set the DIP switch SET5-4.
For details of switch, refer to "Terminal resistor setting" on
page 07-63.
↓
<Step 3>
Indoor unit connection check
For details, refer to "Indoor unit connection check" on page
07-64.
↓
<Step 4>
Function setting
¢ Indoor unit setting
For the actual switch positions, refer to "Function settings" on page 07-66.
<Step 1>
Refrigerant circuit address setting
Set the rotary switch REF AD x10 and x1.
For details, refer to "Address setting" on page 07-4.
↓
<Step 2>
Indoor unit address setting
Set the rotary switch IU AD x10 and x1.
For details, refer to "Address setting" on page 07-4.
↓
<Step 3>
Remote controller address setting
Set the rotary switch RC AD.
For details, refer to "Address setting" on page 07-4.
↓
<Step 4>
Function setting
1-1. System type setting - (07-2) - 1. System settings
FUNCTION SETTINGS FUNCTION SETTINGS