Fujitsu AJ 126LELDH Series - Wired Remote Controller (Touch Panel)

2-16. Wired remote controller (Touch panel)
¢ Remote controller address confirmation
When “R.C. Address Setting” on the Maintenance screen is touched, Installer Password Verification
screen is displayed.
Enter the Installer Password, and touch “OK”. R.C. Address Setting screen is displayed.
Previous
Page
Back
Next
Page
Page 2/ 3 Maintenance
Test Run
R.C. Address
Setting
Function Setting
I.U. Address
Setting
[001–01]
R.C.Address Setting
Current Address
Back
Manual Addressing
Address Reset
R.C.address
(Unit No.)
When the address
is set manually, this
mark is displayed.
When the “Back” is touched, the display returns to the Maintenance screen.
NOTE:
The address of this unit is set automatically. Do not change the indoor unit remote con-
troller address from the factory setting “0”. (Verify that the address is “0”.)
¢ Manual address setting of the remote controller
1. Touch “Manual Addressing” on the R.C. Address Setting screen.
[001–01]
R.C.Address Setting
Current Address
Back
Manual Addressing
Address Reset
2. Manual Addressing screen is displayed. Set the address by touching “ ” or “ ”.
01001
Manual Addressing
Cancel OK
System Unit
When “OK” is touched, a verification screen is displayed.
3. When the “Yes” on the verification screen is touched, a message screen is displayed.
No Yes
Manual Addressing
Manual address setting will be started. OK?
2-16. Wired remote controller (Touch panel)
- (07-121) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS