Fujitsu AJ 126LELDH Series - Page 920

4. When the “Yes” on the verification screen of indoor unit verification is touched, all indoor units
will stop, and the verification mode starts.
No Yes
I.U. Address Verification
Indoor unit position will be checked. OK?
5. When indoor unit position verification ends, a screen displaying the indoor units in a list is dis-
played. When the screen has multiple pages, they can be switched by touching the “Next Page”
or “Previous Page”.
1 002–1 01–01 /
2 002–2 01–02 /
3 002–3 01–03 /
/
End
Next
Page
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
End
Next
Page
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
When the indoor unit address to be verified is touched, the appropriate indoor unit performs the
air blow and the LED lamps blink*. (*Only when the indoor unit has that function.)
1 002–1 01–01 /
2 002–2 01–02 /
3 002–3 01–03 /
/
End
Next
Page
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
6. When the “End” is touched, the display returns to the I.U. Address Verification screen men-
tioned in step 2.
1 002–1 01–01 /
2 002–2 01–02 /
3 002–3 01–03 /
/
End
Next
Page
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
When “Back” on the I.U. Address Verification screen is touched, the display returns to the Main-
tenance screen.
1 002–1 01–01
/
002–2 01–02
/
2
002–3 01–03
/
3
002–4 01–04
/
4
002–5 01–05
/
5
002–6 01–06
/
6
/
Page 1/ 2 I.U. Address Verification
No. System–Unit Ref.–In.
Back
Check
Next
Page
2-16. Wired remote controller (Touch panel)
- (07-124) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS