¢ Installation
Unit: mm
• When the cable is attached to the wall:
– Remove the material covering the wiring penetration (thin material) in the cover of the sensor
unit with a pair of cutters. The cable passes through this hole.
– Attach the remote sensor unit on the wall using the screws.
40
Screw
(M4 × 16)
Mounting hole dimensions
55
– Fit the cover on the remote sensor unit and screw it in place.
• When the cable is buried in the wall:
– Remove the material (thinner than the surrounding material) in the wiring hole on the remote
sensor unit using a pair of cutters.
– Drill a hole in the wall for the cable.
– Seal the area around the cable penetration with putty.
20 20
ø6 to ø10
1
Screw
(M4 × 16)
Mounting hole dimensions
55
– Fit the cover on the remote sensor unit and screw it in place.
¢
Specifications
Dimensions (H × W × D) mm 70.2 × 55.2 × 18
2-20. Remote sensor unit (UTY-XSZX) - (05-109) - 2. Control units
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
