¢ Dimensions
Unit: mm
Top view
Top view Side view
38
15
71
96
12.512.5
¢
Installation
1. With referring the setting manual, perform wire connection.
2. Install the WLAN adapter in the direction as shown in this figure. If the WLAN adapter is in-
stalled in the wrong direction, water may get into the adapter through the wire, causing failure.
Tapping screws
(Accessories)
GOOD
PROHIBITED
Reverse direction On a curved surface
On the floor
3. Connect the remote controller cable to the connecting cable, and insert it to the connector. Set
the DIP switch (SW1) on the PCB of indoor unit to “2WIRE”.
3-11. Wireless LAN adapter (UTY-TFSXZ1)
- (05-182) - 3. Adaptor/Convertor units
CONTROL
SYSTEM
CONTROL
SYSTEM
To Next Page
Loading...
