Indoor unit address setting
NOTE:
Perform this setting on the master remote controller.
1. By pressing the + or - button, select a remote controller address. (Select the indoor unit you
want to operate.) Then pres the ENTER button.
Example: When remote controller address “01” is selected
Remote controller address
2. By pressing the + or - button, display function number “01”. Then press the ENTER button.
3. By pressing the + or - button, set up the indoor unit address. (The setting range is from “00” to
“63”.)
Example: When indoor unit address data “12” is set up
Indoor unit address
ERROR GOOD
• When the address data is properly set up on the indoor unit, the set number will be dis-
played. (GOOD)
• When the address data is not set up correctly, “- -” is displayed. (ERROR) Back to the previ-
ous step and set up the indoor unit address data again.
4. To return to the address selection screen, press the ENTER button. If setting has been com-
pleted, press MENU button to return to the Menu 2 item selection screen.
1-4. Address setting by remote controller
- (07-52) - 1. System settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
