Fujitsu AJ 126LELDH Series

To Next Page

To Previous Page

3. When “F3” is displayed on the LED104, press the ENTER button (SW109). Indicator on the

LED105 flashes.

LED105 LED104

4. Press the SELECT button (SW108) to display “10” on the LED105.

LED105 LED104

5. When “10” is displayed on the LED105, hold down the ENTER button (SW109) for 3 seconds

or longer. (Unless it is held down for at least 3 seconds, the selection will not be confirmed.)

When the automatic address setting function is activated, the display changes to “run.”

LED105 LED104

6. When the automatic address setting is completed, the number of signal amplifier is displayed

on the LED104. Verify that the count matches the number of signal amplifiers being installed.

LED105 LED104

Example: When 8 signal amplifiers are being connected

7. To exit the automatic address setting, press the ENTER button (SW109) in the setting complet-

ed status shown in the previous step.

LED105 LED104

8. To exit the function mode, press the MODE/EXIT button (SW107).

LED105 LED104

Fujitsu AJ 126LELDH Series - Page 854