Fujitsu AJ 126LELDH Series - Page 887

2. Function number to be confirmed is displayed on the remote controller LCD.
Press the SET TEMP. or button to adjust the setting number. Each time the MODE button
is pressed, it switches between the left digit and the right digit.
Press the TIMER set (-) button.
Case1: When setting number is one digit Case2: When setting number is two digits
Example) Function number: 26; Setting number: 31
0.5sec ON / 0.5sec OFF
0.5sec ON / 0.5sec OFF
OFF
OFF
1 time
3 times
2 times
6 times
...
...
...
(Phase1) : 12sec (Phase2) : 12sec
0.5sec ON / 0.5sec OFF 0.5sec ON / 0.5sec OFF
Example) Function number: 30; Setting number: 01
OPERATION lamp
(Green)
TIMER lamp
(Orange)
FILTER lamp
(Red)
OPERATION lamp
(Green)
TIMER lamp
(Orange)
FILTER lamp
(Red)
0.5sec ON / 0.5sec OFF
OFF
1 time 1 time
3 times 3 times
...
...
(Phase1) : 12sec (Phase1) : 12sec
0.5sec ON / 0.5sec OFF
TIMER set (-)
2-4. Indoor unit (setting by wireless remote controller)
- (07-91) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS