Fujitsu AJ 126LELDH Series - Page 902

2. By pressing the + or - button, select the function number. Then press the ENTER button.
Function number
3. By pressing the + or - button, select the setting number.
Example) Function number: 30; Setting number: 01
ERROR GOOD
Setting number
• When the address data is properly set up on the indoor unit, the set number will be dis-
played. (GOOD)
• When the address data is not set up correctly, “- -” is displayed. (ERROR) Back to the previ-
ous step and perform the setting again.
4. To return to the address selection screen, press the ENTER button. If setting has been com-
pleted, press MENU button to return to the Menu 2 item selection screen.
RELATED LINKS
"Completion of setting mode" on page 07-53
"Function details" on page 07-108
¢ Setting up each indoor unit
Setting must be performed on each indoor unit by repeating following procedures.
• "Preparation" on page 07-105
• "Indoor unit function setting" on page 07-105
Wired remote
controller
Wired remote
controller
Wired remote
controller
0001 0101 0201 1301 1401 15010 0 0 0 0 0
Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit Indoor unit
2-9. Indoor unit (setting by UTY-RLR
)
- (07-106) - 2. Function settings
FUNCTION SETTINGS FUNCTION SETTINGS