• SW4: Setting prohibited
SW4 Factory setting
OFF Fixed at OFF ♦
ON Setting prohibited
• SW5: Setting prohibited
SW5 Factory setting
OFF Fixed at OFF ♦
ON Setting prohibited
• SW6: Memory backup setting (Only for wired remote controller)
Set to “ON” to use batteries for the memory backup.
If there is a power failure when this setting is enabled, all the settings stored in the memory
will be saved.
SW6 Memory backup Factory setting
OFF Disable ♦
ON Enable
NOTE: Never turn it “ON” in the case of simple remote controller.
2-12. Simple remote controller (UTY-RSK, UTY-RHK) - (07-115) - 2. Function settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
