¢ Group remote controller address setting
1. To start the setting, hold down the set time buttons
and simultaneously for 2 seconds
or more.
2. Press the set time buttons to set the group remote controller address.
Reverse Advance
Check that it is .
Group remote controller address
3. Press the ENTER button. Check the and flash for 2 seconds.
4.
To complete the setting, hold down the set time buttons and simultaneously for 2
seconds or more again.
2-13. Group remote controller - (07-117) - 2. Function settings
FUNCTION
SETTINGS
FUNCTION
SETTINGS
To Next Page
Loading...
