127
PRIMERGY RX300 S3 User’s Guide
4
Manual OS Installation
● When a recognized network adapter is present
Perform "■ Updating the LAN Cards" (pg.127) on the LAN device name under [Network adapters],
then "
■ Installing the LAN Driver" (pg.128) on [Ethernet controller] under [Other devices].
● When a recognized network adapter is not present
Perform "■ Installing the LAN Driver" (pg.128) on [Ethernet controller] under [Other devices].
■ Updating the LAN Cards
Perform the following procedures on all LAN device names under [Network adapters] in [Device
Manager].
1 Click [Start] → [Administrative Tools] → [Computer Manager].
2 Click [Device Manager].
3 Double-click a LAN device name under [Network adapters].
Names of the LAN devices are displayed as follows.
4 Insert the driver disk created from the ServerStart CD-ROM into the server.
5 Click [Update Driver] in the [Driver] tab window.
The "Welcome to the Hardware Update Wizard" window appears.
6 Check [No, not this time] and click [Next].
7 Select [Install the software automatically (Recommended)] and click [Next].
The driver will be installed.
8 Click [Finish].
9 Click [Close] to close the properties window.
table: LAN device name
LAN cards LAN device name
Onboard LAN (1000BASE-T) Broadcom NetXtreme Gigabit Ethernet
PG-1862 Intel(R) PRO/1000 MT Dual Port Network Connection
PG-1882(L) Intel(R) PRO/1000 MF Server Adapter
PG-1892(L) Intel(R) PRO/1000 MT Server Adapter
To Next Page
Loading...
