139
PRIMERGY RX300 S3 User’s Guide
5
Operations after OS Installation
■ Paging File Setting
Set up the paging file according to the following procedures:
1 Log on to the server with administrator privileges.
2 Check free space of the drive where the system is installed.
Check the required amount of free space according to "■ Checking Hard Disk Free Space"
(pg.136).
If the drive has no free space, refer to "
■ Cannot collect the memory dump" (pg.269).
3 Click [Start] → [Control Panel] → [System].
The [System Properties] window appears.
4 Click the [Advanced] tab and click [Settings] in [Performance].
The [Performance Options] window appears.
5 Click the [Advanced] tab.
To Next Page
Loading...
