144
Chapter 5 Operations after OS Installation
5 Click the [Advanced] tab and click [Performance Options].
The [Performance Options] window appears.
6 Click [Change] in the [Virtual memory] section.
The [Virtual Memory] window appears.
7 Specify the drive where the paging file is to be created.
In [Drive], select the drive where the system is installed.
The selected drive is displayed in [Drive] in [Paging file size for selected drive].
8 Specify the [Initial size].
The value depends on the type of the set dump file.
Specify a value larger than the value shown in [Recommended] in [Total paging file size for all
drives].
When a smaller value is specified for the paging file size, performance may be affected. We
recommend to specify the paging file size larger than the recommended value.
9 Specify the [Maximum size].
Specify a value larger than the [Initial size].
To Next Page
Loading...
