215
PRIMERGY RX300 S3 User's Guide
7
Installing Internal Options
4. Turn back the SAS backplane and close the both holders at the back of the 3.5-inch
storage bay.
5. Connect each cable.
• Connect the power cable to the power connector at the back of the hard disk unit.
• Pull out the SCSI cable and connect it to the connector of the SCSI card (PG-1281 or
PG-1301L). For how to install the SCSI card, refer to "7.5 Installing Expansion Cards"
(
pg.195)
• Connect the SMB cable to the SMB connector.
SCSI cable
Power cable
SMB cable
To Next Page
Loading...
