216
Chapter 7 Installing Internal Options
11 Pull in the SCSI cable into the side of the device and attach the three cable
covers.
To attach, perform the removal procedure in reverse. Be careful with the front and back of the
cover when attaching it.
12 Attach the fan cage and all the fans.
To attach them, simply perform the removal procedure in reverse.
13 Install the internal hard disk unit and rest of the dummy units.
To attach them, simply perform the removal procedure in reverse.
14 Attach the USB connector to the server.
Push all the way seated in the server. It automatically locks.
15 Attach the L cover and the fan duct.
16 Attach the top cover.
"7.2 Installing/Removing the Top Cover" (pg.182)
17 Push the server back into the rack.
■ How to Remove the Internal Backup Device
To remove the internal backup device, simply reverse the installation procedure.
To Next Page
Loading...
