Fujitsu Primergy RX300 S3 - Page 237

237
PRIMERGY RX300 S3 User's Guide
8
Configuring Hardware and Utilities
■ The ATA Controller Config Submenu
Sets the Serial ATA.
USB Host Controller Enabled (Unchangeable) Sets whether or not to use the USB controller (2.0
or 1.1 standard).
USB 2.0 Host Controller Enabled (Unchangeable)
USB BIOS Supported
Devices
Auto (Unchangeable) Sets which type of USB device should be used in
BIOS.
USB Boot Delay 0 sec. (Unchangeable) Sets the waiting time for booting from a USB
device.
USB BIOS Hot-Plug Enabled (Unchangeable) Allows Hot-Plug of the USB device used for BIOS.
ATA Controller Config Configures additional settings.
"
■ The ATA Controller Config Submenu" (pg.237)
Diskette Controller Enabled (Unchangeable) Sets whether or not to enable the floppy disk
controller.
Mouse Controller Auto Detect
(Unchangeable)
Sets whether or not to use the mouse connected to
the mouse port.
Onboard Video Enabled (Unchangeable) Sets whether or not to enable the onboard video
controller.
SAS Controller Enabled (Unchangeable) Sets whether or not to enable the onboard SAS
controller.
SAS Option ROM Scan Enabled (Unchangeable) Sets whether or not to initialize the extended ROM.
RAID Enabled (Unchangeable) Sets whether or not to enable RAID.
LAN Controller Channel A & B
(Unchangeable)
Sets whether or not to enable the onboard LAN
controller (channel A, or channel A & B).
LAN Remote Boot • Disabled (Initial value)
•PXE
Sets whether or not the OS may be loaded from the
server. This function is used especially when no
floppy disk drive or hard disk drive are installed, or
when both are turned off.
LAN Remote Boot Ch.B
Management LAN Enabled (Unchangeable) Sets whether or not the iRMC uses LAN B. The
iRMC uses the channel B of the onboard LAN
shared with the OS.
table: Items on the ATA Controller Configuration Submenu
Item Setting Description
S_ATA Mode Native (Unchangeable) Sets the Serial ATA mode.
Primary IDE Channel Enabled (Unchangeable) Sets whether or not to enable the IDE channel.
Tertiary IDE Channel Enabled (Unchangeable)
Quaternary IDE Channel Enabled (Unchangeable)
table: Items on the Peripheral Configuration Submenu
Item Setting Description