6. SETTINGS ON WEB INTERFACE
6-13
7. Click the [Apply] button.
The message "Restart the system to apply the changes." appears.
8. Click the [OK] button.
The message "Restart the system to apply the changes." appears.
9. Click the [Close] button to close the message.
Restart the equipment to apply the settings.
6.6.2 How to set up the DHCP lease
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin], [Network Settings], [LAN], then [Basic Settings].
3. Click the [Lease Information] button.
4. Referring to the table below, set up the DHCP lease.
Item Description
Delete button Put a [9] in the box on the left side of the item to delete.
To select all items, put a [9] in the box beside the [IP Address]
title.
Add lease button Input the new lease information.
1) Click the [Add lease] button.
2) Input the manually assigned IP address (IPv4 address).
3) Input the MAC address of device to be registered.
4) Click the [Add] button.
To cancel all changes and close the window, click the [Can-
cel] button.
5) Click the [Close] button to close the window.
Back button Return to the [Basic Settings] menu.
IP address Shows the assigned IP address.
MAC address Shows the MAC address of the network device for the assigned
IP address.
Status Automatic: Automatic assignment
Manual: Manual assignment
Switch to Manual
button
Change from automatically assigned to manually assigned. The
maximum of 100 is for manual assignment.
Edit button Change the lease information (Appears in manual assignment
only).
1) Click the [Edit] button.
2) Change the manually assigned IP address (IPv4 address).
3) Change the MAC address of device to be registered.
4) Click the [Save] button.
To cancel all changes and close the window, click the [Can-
cel] button.
5) Click the [Close] button to close the window.
Registered/available countRegistered/available countRegistered/available count
To Next Page
Loading...
