Furuno FELCOM501 - Remote Control

6. SETTINGS ON WEB INTERFACE
6-44
How to export a access statistics/speed graph data file
Export a access statistics/speed graph data from the Communication Unit to a PC.
1. Click the [Export] button.
The [Save] dialog box appears.
2. Input the file name, then click [Save].
The access statistics/speed graph data is saved in zip format.
6.9 Remote Control
The Remote access lets you access the Web interface of FELCOM251/501 via inter-
net.
Note: The Remote access settings must be done by the network administrator.
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin] in the menu bar.
3. Click [Remote Control Settings].
4. Click [Access Control].
5. Click the box on the left side of [Enabled] to add/remove the check mark ([9]).
To enable remote access, add the check mark. To disable remote access, remove
the check mark.
6. Input the port number in [Port number] (1-65535).
Set the port number, then access http://<WAN IP address>:<Port number>.
Note: It is recommended to assign a port which is not regularly used.
7. Click the [Edit] button, then set the trusted IP address as appropriate.
Note: If no IP address is input, all IP addresses can access the Web interface of
FELCOM251/501. It is recommended to assign at least one trusted IP address.
8. Click the [Save] button.
The message "Applied." appears.
9. Click the [Apply] button.
The message "Applied." appears.
10. Click the [Close] button to close the message.