3. SETTINGS FOR IP HANDSET
3-8
3.4.3 How to connect/disconnect the data line
You can connect or disconnect a data line of a WAN group to which IP Handset be-
longs. You can check with the Web interface to which group your IP Handset belongs.
Note 1: When Fleet Xpress mode is active, this menu is not available.
Note 2: Data communication is not available from the IP handset.
1. In the [Comm. Unit] menu, press T to select the [Data Line] menu, then press the
Enter key.
The [Data Line] screen appears.
2. Press W or X to select [Disconnect] or [Connect] as appropriate, then press the
Enter key.
[Connect]: Enable data communication for the network equipment connected to
the same WAN group as this IP Handset.
[Disconnect]: Disable data communication for the network equipment.
3. Press the key to go back to the main screen.
Note: In some cases, it can take a few minutes to establish a data line connection.
3.5 IP Handset Information
You can check the system information and call restrictions for each IP Handset.
1. At the main screen, press the Enter key to open the main menu.
2. Press W, S, X or T to select the [Info] menu, then press the Enter key.
The [Information] menu appears.
To Next Page
Loading...
