Furuno FELCOM501 - How to Use Local Time; Operations for Communication Unit

3. SETTINGS FOR IP HANDSET
3-5
3.3.2 How to use local time
To use local time, do the following:
1. In the [Time] screen, press S or T to select the [Time Offset] field.
2. Press X to select [ON].
3. Press S or T to select the [UTC] field for hour.
4. Press W or X to set the time difference for hour (-12 to +13).
5. Press S or T to select the [UTC] field for minute.
6. Press W or X to set the time difference for minute (00, 15, 30, 45).
7. Press the Enter key do display the [DST] screen.
8. Press W or X to select [OFF] or [ON], then press the Enter key.
When you select [ON], the time advances one hour.
9. Press the Enter key to confirm the settings.
The message "Applied." appears.
10. Press the key to go back to the main screen.
3.4 Operations for Communication Unit
This section explains the following contents:
• How to display the [Status] screen
• How to search for a satellite
• How to connect/disconnect the data line
1. At the main screen, press the Enter key to open the main menu.
2. Press W, S, X or T to select the [Comm. Unit] menu, then press the Enter key.
The [Comm. Unit] menu appears.