Furuno FELCOM501 - How to Register;Edit WAN Group as Bridge

6. SETTINGS ON WEB INTERFACE
6-30
6.8.3 How to register/edit WAN group as "Bridge"
The "Bridge" mode assigns the WAN IP address provided by Inmarsat to a device con-
nected to the specified LAN port on the Communication Unit. The Communication Unit
cannot set the NAT, Firewall, IP filter, or DNS filter.
Note 1: Set Firewall and traffic limitation at the user’s network device.
Note 2: The Bridge mode settings must be done by the network administrator.
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin], [Network Settings], [WAN], then [Groups].
3. Click [Add group].
The following pop-up window appears.
To edit a WAN group, click the [Settings] button for the WAN group to edit. Edit
the settings referring to this step and later.
4. Referring to the following table, set up the connection type and the group name.
Item Description
Connection Type Select "Bridge mode".
Group name Input the group name.
Next button Go to the next step.
Cancel button Close the pop-up window.