6. SETTINGS ON WEB INTERFACE
6-15
6.7 ISDN Settings
Set for the equipment that is connected to the USB port via "USB-RS232C Converter".
1. Referring to section 6.1, login as an Administrator.
2. Click [Admin] in the menu bar.
3. Click [ISDN Settings] to show the [ISDN Settings] menu.
4. Referring to the table below, set up the ISDN service.
5. Click the [Apply] button.
The message "Applied." appears.
6. Click the [Close] button to close the message.
Item Description
Serial Communication
Baud rate Shows the preset baud rate.
The setting cannot be changed.
Parity Shows "None".
The setting cannot be changed.
Flow Control Shows "Hardware".
The setting cannot be changed.
Auto Connection
Auto connection
when incoming
Turn the setting on to connect ISDN automatically when receiving
an incoming call, then the data communication starts via the USB
port.
Ring times Set the ring tone number when receiving the ISDN call until auto-
matic connection.
This menu appears in grey when turning the [Auto connection
when incoming] menu off.
To Next Page
Loading...
