APPENDIX 3 NOTIFICATION MESSAGES
SIM errors/events appear in the IP Handset and in the Web interface of the Communication Unit.
The list below shows the notification messages that may appear.
Notification priority level is annotated in the "Lvl" column as follows:
Warning: "W"; Error: "E"; Info: "I"; no priority: "-"
Code Lvl BDU/Web UI Message Handset Message Explanation/Remedy
0x2000001A
䠉
Under processing. The Comm. Unit is
under processing.
The Comm. Unit is
under processing. Try again later.
0x2F0000FE W Configuration failed. Configuration
failed.
Configuration failed. Restart the
Communication Unit and try again.
0x1400 W No satellite signal. NA The FELCOM system no longer receives a
signal from the satellite.
0x2000 I Weak satellite signal. NA The signal from the satellite is weak.
0x804C W The selected satellite is
not available at the
current position.
The satellite is not
visible from here.
The terminal is set up to use a satellite that is
not visible at the current GPS position.
0x8059 W Unable to point on
satellite because;
- satellite is under
horizon or;
- Antenna blockage or;
- Antenna HW is
malfunction;
- Too high vibration.
Unable to point on
satellite.
Unable to point on satellite because;
- satellite is under horizon or;
- Antenna blockage or;
- Antenna HW is malfunction;
- Too high vibration. Make sure Antenna is not
blocked and vibrations is within the specified
limit. Then restart the Communication Unit. If
the problem persists, contact your dealer.
0x1600 W Rescue calls only. Rescue calls only. The SIM card is not accepted by the network.
Only emergency calls are allowed.
0x1700 W Registration for voice
service failed.
Registration for
voice service
failed.
Registration for voice service failed. If the
problem persists, contact your SIM provider.
0x1800 W Registration for data
service failed.
Registration for
data service
failed.
Registration for data service failed. If the
problem persists, contact your SIM provider.
0x8049 W Data transfer speed
reduced due to high
temperature.
Data speed reduced
due to high
temperature.
The bit rate of the data channel is reduced
because the temperature is too high.
0x10204 W Data transfer speed
reduced due to high
temperature and all
streaming connections
closed.
Data communication
is limited due to
high temp.
Data transfer speed reduced due to high
temperature and all streaming connections
closed. Move the Communication Unit to a
cooler place.
0x10205 W All data connections
are closed due to high
temperature.
Data communication
is not available
due to high temp.
All data connections are closed due to high
temperature. Move the Communication Unit to
a cooler place.
0x802F E Antenna start up failed. Antenna start-up
failed.
Antenna main image could not be loaded
0x8030 E Antenna start up failed. Antenna start-up
failed.
Antenna could not enter main application
mode
0x8031 E Antenna start up failed. Antenna start-up
failed.
Failed to enter normal operation
AP-8
To Next Page
Loading...
