APPENDIX 3 NOTIFICATION MESSAGES
Code Lvl BDU/Web UI Message Handset Message Explanation/Remedy
0x8045 W Antenna start up failed
due to low temperature.
Antenna start-up
failed due to
low temperature.
The temperature in the Antenna is too low for
the system to start up.
0x10300 W Updating software. Updating software. Updating software. Wait for the completion of
update.
0x10302 W Preparing the software
update.
Preparing the
software update.
Preparing the software update. Wait for the
completion of update.
0x8035 E Communication error
between Antenna and
Communication Unit.
Communication
error between
Antenna and
Comm.
Unit.
There was an error communicating with the
Antenna.
0x8054 W Transmission aborted
due to extreme
temperature.
Transmission
aborted due to
extreme
temperature.
The system stops all transmission due to:
• critically high temperature in the HPA or
ACM module of the Antenna, or
• too low temperature in the ACM module.
0x9129 W GPS module error. GPS module error. GPS module error. If the problem persists,
contact your dealer.
0x9128 W GPS module error. GPS module error. GPS module error. If the problem persists,
contact your dealer.
0x911F W Lost connection to the
GPS receiver.
Lost connection to
the GPS receiver.
Communication with the GPS receiver in the
Antenna is lost
0x962D W Lost connection to the
GPS receiver or GPS
fixed lost.
Lost connection to
the GPS receiver
or GPS fixed lost.
Lost connection to the GPS receiver or GPS
fixed lost. Restart the Communication Unit. If
the problem persists, contact your dealer.
0x8009 W Antenna unit is turned
off because input
voltage to
Communication Unit is
too low.
Antenna unit is
off because of low
input voltage.
The power supply to the terminal has dropped
for too long. The Antenna does not have
enough power to function.
0x1010 W The Communication
Unit temperature is too
low.
The Comm. Unit
temperature is too
low.
Low ambient temperature is causing the
performance of the terminal to be degraded or
halted.
0x1000 I Low temperature. No
performance degrade.
Low temperature.
No performance
degrade.
Low temperature. No performance degrade.
0x1020 W Caution!
Ambient temperature is
too low.
Caution!
Ambient temp.
is too low.
Low ambient temperature is causing the
performance of the terminal to be degraded or
halted.
The terminal will assume radio silence if the
problem is in the ACM module of the
Antenna.
0x1110 W Caution!
Communication Unit
temperature extremely
high.
Caution!
Comm. Unit temp.
extremely high.
Terminal: Critically high temperature is
causing the terminal to shut down.
Antenna: Critically high temperature is
causing the Antenna to stop transmission.
0x1120 W Caution!
Ambient temperature is
too high.
Caution!
Ambient temp.
is too high.
High ambient temperature is causing the
performance of the terminal to be degraded or
halted.
If the problem is in the terminal: All PoE ports
are shut down, except port 1 and the bit rate
for Standard data is reduced. If the problem is
in the Antenna: The bit rate is reduced.
AP-9
To Next Page
Loading...
