Furuno FELCOM501 - Page 186

APPENDIX 3 NOTIFICATION MESSAGES
Code Lvl BDU/Web UI Message Handset Message Explanation/Remedy
0x1100 I High temperature. No
performance degrade.
High temperature.
No performance
degrade.
High temperature. No performance degrade.
0x9112 W The Antenna
temperature is too high.
The Antenna
temperature
is too high.
The Antenna temperature is too high. Switch
off the system until the Antenna temperature
cools down.
0x9628 W The Antenna
temperature is too high.
The Antenna
temperature
is too high.
The Antenna temperature is too high. Switch
off the system until the Antenna temperature
cools down.
0x10206 E The Communication
Unit will restart due to
critically high
temperatures.
The Comm. Unit
will restart due
to high temp.
The Communication Unit will restart due to
critically high temperatures. Move the
Communication Unit to a cooler location. For
information on ambient temperature limits,
see the operator's manual. If the problem
persists, contact your dealer.
0x8098 W DC power loss between
BDU and HPA is too
big.
DC power loss
between BDU and
HPA is too big.
DC power loss between BDU and HPA is too
big. Make sure Antenna cable connector has
no corrosion.
Make sure all Antenna cable connectors is
screwed tight together.
0x9113 W Antenna input voltage
is out of range.
Antenna input
voltage is out of
range.
Antenna input voltage is out of range. Check
input voltage to the Communication Unit is
within 10 – 32 V DC.
Check Antenna cable is screwed sufficient
together.
0x9126 W MDM voltage in the
Antenna is out of
range.
MDM voltage in the
Antenna is out of
range.
MDM voltage in the Antenna is out of range. If
the problem persists, contact your dealer.
0x921E W HPA voltage in the
Antenna is out of
range.
HPA voltage in the
Antenna is out of
range.
HPA voltage in the Antenna is out of range.
Check input voltage to the Communication
Unit is within 10 – 32 V DC.
Check Antenna cable is screwed sufficient
together.
0x9223 W Unexpected HPA
voltage in the Antenna
is detected.
Unexpected HPA
voltage in the
Antenna is
detected.
Unexpected HPA voltage in the Antenna is
detected. Restart the Communication Unit. If
the problem persists, contact your dealer.
0x9629 W ACM voltage in the
Antenna is out of
range.
ACM voltage in the
Antenna is out of
range.
ACM voltage in the Antenna is out of range.
Check input voltage to the Communication
Unit is within 10 – 32 V DC.
Check Antenna cable is screwed sufficient
together.
0x912A W The motors in the
Antenna have stopped
due to extreme
temperature.
The motors in the
Antenna have
stopped due to
extreme temp.
The motors in the Antenna have stopped
because the temperature is critically high or
critically low.
0x9636 W The motors in the
Antenna have stopped
due to extreme
temperature.
The motors in the
Antenna have
stopped due to
extreme temp.
The motors in the Antenna have stopped
because the temperature is critically high or
critically low.
0x9221 W Gain settings error in
HPA.
Gain settings
error in HPA.
Gain settings error in HPA. Restart the
Communication Unit. If the problem persists,
contact your dealer.
AP-10