EasyManua.ls Logo

Furuno FELCOM501 - Page 189

Furuno FELCOM501
205 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
APPENDIX 3 NOTIFICATION MESSAGES
Code Lvl BDU/Web UI Message Handset Message Explanation/Remedy
0x10400 W Short circuit detected
on USB port.
Short circuit
detected on USB
port.
Short circuit detected on USB port. Restart
the Communication Unit. And check the
connected device. If the problem persists,
contact your dealer.
0x8099 E BP in Communication
Unit has detected some
errors.
BP has detected
some errors.
BP in Communication Unit has detected some
errors. If too many errors detected, contact
your dealer.
0x3900 W DSP in Communication
Unit has detected
error(s).
DSP has detected
some error(s).
DSP in Communication Unit has detected
error(s).This can be caused by H/W error or
interference. If the problem persists without
interference, contact your dealer.
0x4000 I DSP in Communication
Unit has detected a
suspicious condition.
NA DSP in Communication Unit has detected a
suspicious condition. If any communication
error happens and persists, contact your
dealer.
0x10800 W Failed to enable/verify
Call Waiting for Multi
voice.
Failed to enable
or verify Call
Waiting for Multi
voice.
Failed to enable/verify Call Waiting for Multi
voice. Contact your SIM card provider to
verify the supplementary service is enabled.
0x10801 W Failed to enable/verify
Call Forwarding for
Multi voice.
Failed to enable
or verify Call
Forwarding for
Multi voice.
Failed to enable/verify Call Forwarding for
Multi voice. Contact your SIM card provider to
verify the supplementary service is enabled.
0x20001113 W NA Internal error.
(MAC address)
Internal error. (MAC address) Contact your
dealer.
0x10341 W LAN port(s) is/are
running as Half Duplex
mode.
NA LAN port(s) is/are running as Half Duplex
mode. It is not guaranteed to use Half Duplex.
Configure the device(s) connected to the
Communication unit with Full Duplex mode.
0x20001400 W SIM card is not
inserted.
SIM is not
inserted.
No SIM card is detected in the SIM slot.
0x8057 W SIM access error. SIM access error. SIM access error. Try removing and
reinserting the SIM. Contact your distributor if
the problem persists.
0x20002080
No AMS-ISDN phone
connected.
NA The incoming call is not routed because the
phone related to the AMS-ISDN is not
connected / set.
0x20002081
External calls are not
allowed from this
handset.
NA External calls are not allowed from this
handset.
0x20002082
Wrong Caller code
entered.
NA Wrong Caller code entered.
0x20002083
Call destination not
allowed.
NA Call destination not allowed.
0x20002088
The input extension
number is incorrect.
NA The input extension number is incorrect.
0x20002084
Call rejected because
this handset is not the
Safety voice handset.
NA Call rejected because this handset is not the
Safety voice handset.
0x200020FB
NA NA Call failed. Try again.
0x200020FC
NA NA Call Transfer failed. Try again.
0x200020FD
NA NA
0x200020FE
NA NA
Call failed. Try again.
AP-13

Table of Contents

Related product manuals