2. CHART PLOTTER
2-39
2.18 Fish-It
The [Fish-It] function is used to start drift fishing aiming at a specific point such as the
ACCU-FISH icon (see section 7.14) or a log catch icon (see section 4.2.2). Since you
can see information such as the distance and direction to the target point, it is conve-
nient when you are fishing with the engine off.
Note: The [Fish-it] calculation does not consider obstacles in the drift path. Be careful
of any obstacles within the drift path.
How to show the Fish-It item in the pop-up menu
The [Fish-It] item is shown in the pop-up menu whenever you
tap your boat’s track, point, event mark (log catch), or ACCU-
FISH
™
icon. Do as follows to activate the [Fish-It] item. Note
that [Fish-It] appears in the pop-up menu even if the catch
and ACCU-FISH icons are hidden
1. From the Home screen, tap [Settings]→[Chart Plotter].
2. Set [Show Fish-It on Pop-up menu] to [ON].
3. Tap [×] on the title bar to close the menu.
How to use Fish-It
1. On the chart plotter screen, tap the location (point, etc.) where you want to fish.
The pop-up menu appears.
2. Tap [Fish-It].
Range rings appear, centered on the own ship icon. The waypoint is marked with
the icon, and own ship and the waypoint are connected with a solid yellow
line. Also, ship’s track is shown.
Note: The maximum radius of the range ring depends on the setting for [Short/
Long Changeover] in the [Units] menu.
For point
Range ring
Drift-it icon
Waypoint
Track
A solid yellow line
connects between
own ship and the
waypoint.
DTW SOG STW COG
To Next Page
Loading...
