1. SYSTEM INTRODUCTION
1-44
1.22 PIN Code Lock
The PIN code lock feature allows you to require a four-digit password to be entered
upon startup, keeping your data safe against theft.
Follow the procedure below to set the password.
Note 1: Make a note of your password and store it in a safe place.
Note 2: Set a password for each MFD (Multi Function Display) in the network.
1. Open the [Settings]→[General] menu.
2. Turn on [Password Lock].
You will use this password to unlock the MFD. If you forgot the password, the unit
cannot be unlocked (with a new password). Request a Furuno dealer to unlock
the unit. After the unit is unlocked all factory settings are restored. All your user
data (points, routes, tracks, boundaries, catches, photos, settings) will be lost.
3. Tap [OK] to show the password input screen.
4. Enter your password with four digits. You are asked to confirm the password.
5. Re-enter your password. The message "Password protected" appears.
6. Tap [OK] to finish.
To release password protection, turn off [Password Lock] in the above procedure.The
message "The password will removed and all units in the network will no longer be
protected. Are you sure you want to proceed?" Tap [OK].
To Next Page
Loading...
