4. POINTS, BOUNDARIES
4-19
The following occurs:
• The Goto point is highlighted.
• A purple line and a yellow line extend from the own ship icon. The purple line is the
course to follow to get to the point. The yellow line is the shortest course from the
current position to the Goto point.
• The navigation bar (provides destination information) appears at the top of the dis-
play.
For how to use the [Restart] and [STOP] buttons, see section 4.16.
• The waypoint switching method is determined according to the respective setting on
the menu. Select the format by [Settings]→[Routes]→[WPT Switch Mode]. Select
[Circle and Cross Line], [Circle] or [Cross Line].
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Cross Track Error Lines] in the [Settings]→[Routes] menu.
Note: If you want to be notified when you reach the go to point (the end of a route),
turn on [End of Route Notification] in the [Routes] menu (see subsection 5.11.9). The
message "End of Route" appears when you reach the end of a route. For the arrival
timing, see section 5.11.5.
4.15.2 How to go to a position selected on screen
You can set a position as a point to go to without saving the point. The point is erased
when the navigation is canceled or the power is turned off.
1. Tap the position to set as the go to point to show the pop-up menu.
2. Tap [Goto].
STOP (navigation)
button
Restart (navigation)
button
Distance to
waypoint
Bearing to
waypoint
Targeted time of
arrival*
Time to go to next
waypoint*
*
These figures are the same when navigating to a point.
Goto point
XTE (Cross-track Error)
Yellow line: Shortest
course from the current
position to the Goto point.
Purple line: Course between the
Goto point and the point where the
“Goto” function starts.
Arrival area
XTE lines
PORT XTE line (Red), STBD XTE line (Green)
Own ship icon (current position)
To Next Page
Loading...
