Furuno NAVNET TZ2 TZTL12F - Multi-Sounder Display Operations; How to Switch between TX and STBY; How to Switch between Single Beam and Triple Beam Presentations; How to Set the TX Beam Angle

8. MULTI BEAM SONAR DFF-3D
8-6
8.3 Multi-Sounder Display Operations
This section covers the functions available with the multi-sounder display. To show the
[Multi-Sounder] menu, open the Layers menu and then tap [Multi-Sounder Settings].
The [Multi-Sounder] menu can also be accessed from the home screen: Tap [Set-
tings]→[Multi Beam Sonar]→[Multi-Sounder].
8.3.1 How to switch between TX and STBY
Open the Layers menu and then select [ON] for [TX/STBY] to start transmitting, [OFF]
to stop transmitting. "Stand-by" appears at the center of the screen when transmission
is stopped.
8.3.2 How to switch between single beam and triple beam presenta-
tions
1. Open the Layers menu.
2. Tap [Beam Mode].
3. Select [Single Beam] or [Triple Beam].
8.3.3 How to set the TX beam angle
You can set the TX beam angle for the port, starboard and downward beams.
1. Open the Layers menu.
2. Tap [Beam Angle].
3. Select the beam angle.
8.3.4 How to set the TX beam width
You can set the TX beam width for the port, starboard and downward beams.
1. Open the Layers menu.
2. Tap [Beam Width].
3. Select the beam width.