9. FILE OPERATIONS
9-2
3. Tap desired file format, among [TZX], [TZD], [CSV], [GPX].
[TZX]: For NavNet TZtouch2/3
[TZD]: For NavNet TZtouch2
[CSV]
*1
: For NavNet3D
[GPX]
*2
: For use with PC plotter
*
*1
: The CSV format has the following export restrictions:
*2
: When exporting data in GPX format, it is recommended to make a note of the
data contained in the file. GPX files names do not indicate their contents.
4. Tap the close button on the title bar to finish.
9.2 How to Export User Objects
This unit holds a maximum of 30,000 points, 200 routes, 100 polygon areas, (bound-
aries), 100 circles (boundaries), 1,000 screenshots, and 1,000 catches. When the ca-
pacity for routes/points is full, new data cannot be stored. If you need to save the
above-mentioned items permanently, save them to a media, following the procedure
below.
1. Put appropriate formatted media in port (slot).
2. Open the Home screen, then tap [Settings]→[Files]→[Export User Objects].
3. Tap the destination where to export user objects. You are asked if you are sure to
proceed.
4. Tap [OK]. The message "EXPORT SUCCEEDED" appears if the exporting was
successful.
5. Tap [OK] to erase the message.
6. Tap the close button on the title bar to finish.
• Points: Max. 2,000
• Routes: Max. 200 (100 points/route)
• Track: Max. 10,000
To Next Page
Loading...
